Review of pressure pot
Clear and concise instructions and safety information Maintained pressure for 48 hours without need for further pressurisation
Pressure casting compresses air bubbles to sizes hard to detected by the human eye creating a virtually bubble free casting. Simply cast your part in your mould and place your mould into the pressure pot. Apply positive air pressure from any regulated compressor and leave to cure under pressure.
These tanks are modified for casting only and cannot be used for paint. All unused outlets are permanently capped with 150psi 316 stainless steel caps.
The maximum working pressure is governed by a mechanical safety valve, recommended good working practice is to use at a maximum working pressure which is 10psi less than technical maximum.
Internal Dimensions Height = 39cm Diameter = 32cm.
Buy this pot and receive 10% off your next order of Alumilite or Royal Palm resin, Alumilite dyes and powders, Casters Choice mica powders and HDPE moulds. You will be sent a discount code with your pressure put which you can apply on your next order.
(This offer cannot be combined with any other discounts or sale prices).
Saving example;
If you were to stock up on a 16lb Alumilite Clear polyurethane, a 2 gallon Royal Palm epoxy and a full set of Alumilite dyes and Casters Choice Mica powders you'd save a whopping £53. Whether you need lots of stock or are just starting out, BUY and SAVE when you buy one of our pressure pots.
Clear and concise instructions and safety information Maintained pressure for 48 hours without need for further pressurisation
A good pot (the same as I already have from elsewhere