Scratch foam boards - make your own custom textures for metal clay with no need for expensive tools! 

SAMPLE PACK NOW AVAILABLE!

These sturdy but soft sheets lets you use anything from a toothpick, blunt pencil, or ball-point pen, to a ball burnisher, dotting tool, or ball tool, to simply ‘engrave’ into the foam.

You can even press hard objects with interesting patterns, like a shell or a button into the Scratch Art foam board to recreate the pattern in your clay. The areas where you’ve pressed into the foam will become raised areas in your clay. It’s super smooth so can pick up very fine details. 

If you've taken a class with Joy Funnell you know she uses Scratch foam sheets a lot.

To create a texture in the scratch foam: 

1. Draw your design with a pencil or ballpoint pen to make a light impression
2. You can then carefully go over the design with a very fine pin tool or scalpel blade if you want to deepen the cut
3. Finally go over the design with a ball burnisher to create a smooth channel
4. Depending on depth and width of channel required, increase the size of the ball ended embossing tool

Please note - scratch foam is not flexible, and will snap if bent too far. Textures might eventually wear down after a moderate level of use, and after spraying non-stick solutions onto ‘high traffic’ areas.

Thickness of foam is 1mm.

Available in:

• Sample pack 2 x roughly A7
• 4 x A5 (6" x 9")
• 4 x A4 (9" x 12" - these are actually US letter size, so a little wider and shorter than a A4)